HP ProLiant DL360p Gen8 Server - Manual (Page 25)

Operations 25
The server may look different than the one shown in the following illustration, depending on the server
model.
Install the PCI riser cage
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.
1. Power down the server (on page 20 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 20 ).
4. Remove the access panel (on page 23 ).
5. Align the PCI riser boards with the corresponding connectors on the system board, and then install the
cage.
6. Push down on the thumbscrew and rotate 180 degrees.
7. Lower the tab.