HP ProLiant DL360p Gen8 Server - Manual (Page 50)

Hardware options installation 50
6. Install the DIMM.
7. Install the access panel (on page 23 ).
8. Slide the server into the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server (on page 20 ).
Use RBSU (" HP ROM-Based Setup Utility " on page 83 ) to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED
combinations (on page 16 )."
Hot-plug hard drive guidelines
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number (" Device numbers " on
page 17 ).
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.