HP Netserver L Server series - Manual (Page 27)

Chapter 4 Installing Accessory Boards
19
preferred slot locations. If not, consider the boot order (see Figure 4-3)
when choosing the accessory board socket in which to install the board.
Figure 4-3. Accessory Board PCI and ISA Slots
Boot order for PCI controllers is determined by slot location. The system
searches for a bootable device in the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
This boot order can be changed using the SETUP utility (press [F2]
during the boot process).
2. Remove the slot cover for each slot to be used, and store it for future use.
If you are installing any full-length PCI boards, also remove the accessory
board retainer. Push on the tab on the retainer to release it, and then slide
it out of the board guide.