HP ProLiant DL360 G4p Server - Manual (Page 48)

48 HP ProLiant DL360 Generation 4p Server User Guide
•
DIMMs installed in a spare bank must be of equal or greater capacity than
the DIMMs installed in other banks.
For example, if bank A is populated with two 512-MB DIMMs, bank B must
be populated with two 512-MB or greater DIMMs in order for online spare
memory support to function properly.
After installing DIMMs, use RBSU to configure the system for online spare
memory support ("Configuring Online Spare Memory" on page
73 ).
Installing DIMMs
1. Power down the server ("Powering Down the Server" on page 25 ).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26 ).
3. Remove the access panel ("Removing the Access Panel" on page 27 ).
4. If installed, remove the half-length expansion board ("Expansion Board" on
page 58 ).
5. Open the DIMM slot latches.
6. Install the DIMM.
7. If removed, reinstall the half-length expansion board ("Installing an
Expansion Board" on page 59 ).