Creating or deleting pools, Figure 9 pool pane, 9 pool pane – HP StorageWorks XP Remote Web Console Software User Manual
Page 43
43
NOTE:
If the check box is not selected, all check boxes in both tabs are grayed out.
•
Business Copy tab: This tab is for Business Copy XP pairs. For more information, see the
HP StorageWorks Business Copy XP user guide for the XP12000/XP10000/SVS200.
•
Snapshot XP tab: Check boxes indicate the status of Snapshot pairs displayed. If you select or clear a
check box, Snapshot XP pairs in that status are displayed or hidden in the volume list. To use the check
boxes, select the Snapshot XP check box in the Pair Status box.
For more information about Snapshot XP pair status, see ”
•
OK button: Applies settings and closes the Display Filter pane.
•
Cancel button: Resets settings and closes the Display Filter pane.
Creating or deleting pools
1.
Launch Command View XP or XP Remote Web Console.
2.
Click the Volume Manager button. The Volume Manager pane appears.
3.
Select the Pool tab. The Pool pane appears.
Figure 9
Pool pane
You can also use the Pool pane to initialize the pool management block’s V-VOL management area. For
more information, see ”
Initializing V-VOL management areas or pool management blocks
•
Pool Mng. Block total capacity: Total capacity of pool management blocks, including capacity of pool
management blocks in use.
NOTE:
The capacity of the pool management block in use must be less than its total capacity.
•
Pool Mng. Block used capacity: X GB: Capacity of pool management blocks in use.
CAUTION:
The value of Total Capacity in the Pool Information box and the value of Pool Mng.
Block used capacity are approximately equal, but there might be some difference. Even if the value
of Total Capacity in the Pool Information box is updated when pool-VOLs are added to or deleted
from the pool, the value of Pool Mng. Block used capacity is not updated until you click Apply.