HP Smart Array P700m Controller - Manual (Page 8)

Overview of the installation procedure 8
4. Power down the server blade.
5. Remove the server blade from the enclosure.
6. Remove the access panel from the server blade.
7. Install the controller hardware (" Installing the controller hardware " on page 9 ).
8. Reinstall the access panel.
9. Reinstall the server blade in the enclosure.
10. Install an HP 3Gb SAS BL-c Pass-Thru Module in the enclosure.
11. Connect the server blade to the pass-thru module.
12. Connect the pass-thru module to a drive enclosure.
13. Power up the server blade.
14. Update the controller firmware (" Methods for updating the firmware " on page 10 ).
15. (Optional) Set this controller as the boot controller using ORCA (" Setting a controller as the boot
controller " on page 12 ).
16. (Optional) Change the controller boot order using RBSU (" Setting the controller order " on page 12 ).
17. If the controller will not be the boot device, install the device drivers (" Installing device drivers " on
page 14 ).
18. If new versions of the Management Agents are available, update the Management Agents
("
Installing Management Agents " on page 14 ).