HP ProLiant BL660c Gen8 Server Blade - Manual (Page 24)

Setup 24
Server blade signal c7000 interconnect bay c3000 interconnect bay Interconnect bay labels
Mezzanine 3 5 and 6** 3 and 4
7 and 8* 3 and 4
* Dual port mezzanine card ports and four-port mezzanine card ports 1 and 2
** Four-port mezzanine card ports 3 and 4
For detailed port mapping information, see the HP BladeSystem enclosure installation poster or the
HP BladeSystem enclosure setup and installation guide on the HP website
(
http://www.hp.com/go/bladesystem/documentation ).
Connecting to the network
To connect the HP BladeSystem to a network, each enclosure must be configured with network interconnect
devices to manage signals between the server blades and the external network.
Two types of interconnect modules are available for HP BladeSystem c-Class enclosures: Pass-Thru modules
and switch modules. For more information about interconnect module options, see the HP website
(
http://www.hp.com/go/bladesystem/interconnects ).
IMPORTANT: To connect to a network with a Pass-Thru module, always connect the Pass-Thru
module to a network device that supports Gigabit or 10 Gb speed, depending on the
corresponding Pass-Thru model.
Installing server blade options
Before installing and initializing the server blade, install any server blade options, such as an additional
processor, hard drive, or mezzanine card.
Installing a server blade
1. Remove the connector covers.