HP D6000 Disk Enclosure - Manual (Page 21)

Setup 21
6. Install the hard drive.
WARNING: Pinch hazard—Keep hands out of front and rear of chassis when closing hard drive
drawers.
7. When all drives have been installed, close the hard drive drawer.
Installing optional I/O modules
The D6000 ships with two I/O modules, one for each storage drawer. Installing additional I/O modules
expands support from single-domain to dual-domain.
CAUTION: If the I/O module is installed in an enclosure for which it was not designed, the
module will not function properly. Read the labels on the I/O module and the enclosure to confirm
compatibility. For example, an I/O module with a "6G IO module" label is supported for use only
in the 6G, D6000 disk enclosure; an I/O module with no label is supported for use only in a 3G
disk enclosure such as the MDS600.
To install an I/O module:
1. Be sure the hard drive drawer is closed completely.