GE GMR06AAZBB - Manual (Page 10)

10
Safety Instructions
Operating Instructions
Tr
oubleshooting T
ips
Consumer Support
Installation Instructions
Leveling legs
Bottom
hinge
Plug button
Spacer
Hinge cover
Plug buttons
or screws
Hinge
Preparing to install the refrigerator.
Door Reversal (on some models)
1. Remove the small plug button on the left
side of the door top cap.
2. Remove the 3 (2 on some models) plug
buttons or screws on the left side on top of
the cabinet.
3. Remove the plastic hinge cover by lifting it
up by the front edge. Some models also
require removal of a screw.
4. Remove the 3 (2 on some models) screws
from the top hinge.
5. Lift the door up and off the bottom hinge
(right side).
6. Tilt the refrigerator cabinet back to remove
the right leveling leg.
7. Remove the screws on the bottom hinge
(right side) and remove the leveling legs.
Move the bottom hinge to the left side and
secure it with screws. Re-install the leveling
legs.
IMPORTANT: The left leg has a spacer or
spacer feature that must be moved to the right
side leveling leg when the door swing is
reversed.
8. Screw the right leveling leg, with the spacer
in place, back in place on the right side.
9. Position the door on the left bottom hinge.
With the magnetic gasket holding the door
in place, secure the top hinge with screws.
10. Make sure the door is aligned with the
refrigerator cabinet before continuing.
11. Replace the hinge cover on top of
the hinge.
12. Put the plug button in the hole on the right
side of the door cap.
13. Put the 3 (2 on some models) plug buttons
on the right side on top of the cabinet