GE GMR06AAZBB - Manual (Page 6)

6
Safety Instructions
Operating Instructions
Tr
oubleshooting T
ips
Consumer Support
Installation Instructions
Cleaning the Outside
Keep the outside clean. Wipe with a clean cloth lightly dampened with
kitchen appliance wax or mild liquid dish detergent. Dry and polish with
a clean, soft cloth.
Do not wipe the refrigerator with a soiled dish cloth or wet towel. These may
leave a residue that can erode the paint. Do not use scouring pads, powdered
cleaners, bleach or cleaners containing bleach because these products can
scratch and weaken the paint finish.
Protect the paint finish.
The finish on the outside of the refrigerator
is a high quality, baked-on paint finish. With proper care, it will
stay new-looking and rust-free for years. Apply a coat of kitchen/
appliance wax when the refrigerator is new, and then at least
twice a year.
Cleaning the Inside
To help prevent odors, leave an open box of baking soda in the
refrigerator.
Unplug the refrigerator before cleaning.
If this is not practical,
wring excess moisture out of sponge or cloth when cleaning
around the control.
Use warm water and baking soda solution –about a tablespoon
(15 ml) of baking soda to a quart (1 liter) of water. This both
cleans and neutralizes odors. Rinse and wipe dry.
Other parts of the refrigerator–including door gaskets, fruit
and vegetable drawers, and all plastic parts–can be cleaned
the same way.
Do not wash any plastic refrigerator parts in the dishwasher.
Care and cleaning
of the refrigerator.
Replacing the Light Bulb (on some models)
Unplug the refrigerator before replacing a burned-out bulb. Setting the
controls to OFF does not remove power to the light circuit.
The light bulb is located behind the temperature control housing and is
visible through the slots in the housing.
Reach up through the opening at the bottom of the control housing and
gently unscrew the light bulb. Replace with a bulb
of the same or lower wattage.
Using a Philips screwdriver, unscrew the lens and pull horizontally until
the lens is removed. Gently unscrew the light bulb and replace with a
bulb of 15 watts or less.
5
6
4