GE GMR06AAZBB - Manual (Page 11)

Safety Instructions
Operating Instructions
Tr
oubleshooting T
ips
Consumer Support
Installation Instructions
GEAppliances.com
Door Reversal (on some models)
4 Cubic Foot Models
1. Remove the two screws at the back of the
top cover.
2. Remove the top cover by lifting the back up
about 2”and then sliding it forward.
3. Remove the small plug button on the left
side of the door top cap.
4. Remove the three screws on the upper
hinge (right side). Remove the hinge.
5. Remove the three screws at the left hinge
location on the top plate.
6. Remove the screw in the middle of the top
plate and remove the top plate.
7. Lift the door up and off the bottom hinge
(right side).
8. Tilt the refrigerator cabinet back to remove
the right leveling leg.
9. Remove the screws on the bottom hinge
(right side) and the left leveling leg. Move
the bottom hinge to the left side and secure
it with the screws and leveling leg.
IMPORTANT: The left leg has a spacer that
must be moved to the right side leveling leg
when the door swing is reversed.
10. Screw the right leveling leg, with the spacer
in place, back in place on the right side.
11. Position the door on the left bottom hinge.
With the magnetic gasket holding the door
in place, secure the top hinge with screws.
12. Make sure the door is aligned with the
refrigerator cabinet before continuing.
13. Replace the top plate and screws.
14. Slide the top cover back in place and
replace the two screws.
15. Put the plug button in the hole on the right
side of the door top cap.
Leveling legs
Bottom
hinge
Plug button
Spacer
Left hinge location
Upper
hinge
Top cover
Top
plate
Door
top cap
11