GE ZFGP21HZSS - Manual (Page 10)

Installation Instructions
BOTTOM DRAWER
STEP 8 REPLACE THE FREEZER
DRAWERS (CONT.)
Pull out the rail assemblies to the full
length on each side of the cabinet.
There are two tabs on each drawer
rail and two slots on each rail assem-
bly on the refrigerator. Align the
drawer rails with the rail assemblies,
tilt the drawer toward the refrigerator,
and seat the tabs into the slots of the
rail assembly. Lower the drawer into
position.
Replace the hex-head screws to
secure the drawer.
Position connector brackets over
pinion grear assembly and drive
screws into slide bracket (two screws
on each side).
10
STEP 8 REPLACE THE FREEZER
DRAWERS (CONT.)
REPLACE THE 2-PIECE BASKET:
Place the rear of the basket onto the
metal slide brackets. There will be 2 pins
on each underside of the back that will
align for securing the basket.
Seat the front of the basket onto
the metal slide brackets and over the
swing locks.
Turn the swing locks from vertical to hori-
zontal position to lock the basket
in place.
Turn the divider slightly to one side so
the tabs on the front fit into the vent slots
on the basket. Position the divider so the
back locating tabs snap into place in the
back vent slots.
A.
B.
ATTACH AND SECURE THE BOTTOM DRAWER TO
THE SLIDES
screws
C.
D.
A.
D.
C.
B.