Important, Installation instructions, Step 17 remove packaging start icemaker – GE ZFGP21HZSS User Manual
Page 14: Step 18 temperature controls, Step 16 install toekick
14
STEP 17 REMOVE PACKAGING
START ICEMAKER
A. Remove all tape, foam and protective packing from
shelves and drawers.
B. Remove the tie downs from the freezer baskets.
Set the icemaker power switch to the I (on) position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It will
then begin operation automatically. It will take 2–3 days
to fill the ice bin.
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough water
to the icemaker.
STEP 18 TEMPERATURE CONTROLS
• The temperature controls are preset at 37°F
for the refrigerator and 0°F for the freezer.
• Allow 24 hours to stabilize before making adjustments.
STEP 16 INSTALL TOEKICK
• Press toekick into position and reinstall one screw on
each side.
IMPORTANT:
The vented toekick must
remain un ob struct ed for proper air circulation.
Pow er
Sw itch
Toekick Screw
Installation Instructions