GE ZV830SMSS - Manual (Page 12)

Installation Instructions
,167$//$7,21³9(17('727+(2876,'(
6 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
,IKRXVHZLULQJLVQRWZLUH
ZLWKDJURXQGZLUHDJURXQGPXVWEHSURYLGHGE\
WKHLQVWDOOHU:KHQKRXVHZLULQJLVDOXPLQXPEH
VXUHWRXVH8/DSSURYHGDQWLR[LGDQWFRPSRXQG
and aluminum-to-copper connectors.
‡5HPRYHWKHVFUHZVRQWKHMXQFWLRQER[FRYHU
DQGWKHNQRFNRXWRQWKHWRSRUOHIWVLGH
‡6HFXUHWKHKRXVHZLULQJWRWKHMXQFWLRQER[ZLWK
a strain relief.
• &RQQHFWWKHZKLWHOHDGWRWKHEUDQFKFLUFXLWZKLWHOHDG
• &RQQHFWWKHEODFNOHDGWRWKHEUDQFKFLUFXLWEODFNOHDG
‡&RQQHFWWKHJUHHQ\HOORZOHDGWRWKHEUDQFK
FLUFXLWJUHHQOHDGRUEDUHJURXQGOHDG
• Secure all the connections with wire nuts on each
electrical connector.
‡3XVKWKHZLUHVLQWRWKHMXQFWLRQER[DQGUHSODFH
the cover. Be sure the wires are not pinched.
• Secure the MXQFWLRQER[FRYHUZLWKthe 6 RULJLQDO
screws.
7 INSTALL DUCT COVERS
‡5HPRYHSURWHFWLYHSODVWLF
FRYHULQJ
• Place the decorative duct
covers on top of the hood.
NOTE: The inside duct piece
has vent holes on one end.
The holes are intended for
XVHZKHQWKHKRRGLVLQVWDOOHGIRUUHFLUFXODWLQJ
purposes. Slide the inside end into the outer
SLHFH WKHYHQWKROHVVKRXOGQRWEHYLVLEOHLQWKLV
installation.
The inside duct piece must slip into the folded ends
of the outer section.
• ([WHQGWKHLQQHUGXFWXSZDUGWRWKHFHLOLQJEUDFNHW
• Press up on the front corners of the filter cover panel
WRXQORFN/RZHUWKHSDQHOWRDFFHVVWKHILOWHU
‡/RFDWHWKHVFUHZKROHVRQWKHLQVLGHIURQWHGJH
RIWKHRSHQLQJ,QVWDOOVFUHZVWRVHFXUHWKHGXFW
cover to the hood.
0RXQWLQJ
screws
/RZHUGXFW
cover seat
Duct cover
VXSSRUWEUDFNHW
/RZHU
duct cover
8SSHU
duct cover
Duct attachment
WDEV
Screw holes
-XQFWLRQ
ER[FRYHU
12