GE ZV830SMSS - Manual (Page 17)


Installation Instructions
,167$//$7,21³5(&,5&8/$7,1*
6 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
,IKRXVHZLULQJLVQRWZLUH
ZLWKDJURXQGZLUHDJURXQGPXVWEHSURYLGHGE\
WKHLQVWDOOHU:KHQKRXVHZLULQJLVDOXPLQXPEH
VXUHWRXVH8/DSSURYHGDQWLR[LGDQWFRPSRXQG
and aluminum-to-copper connectors.
‡5HPRYHWKHVFUHZVRQWKHMXQFWLRQER[FRYHU
DQGWKHNQRFNRXWRQWKHWRSRUOHIWVLGH
‡6HFXUHWKHKRXVHZLULQJWRWKHMXQFWLRQER[ZLWK
a strain relief.
• &RQQHFWWKHZKLWHOHDGWRWKHEUDQFKFLUFXLWZKLWHOHDG
• &RQQHFWWKHEODFNOHDGWRWKHEUDQFKFLUFXLWEODFNOHDG
‡&RQQHFWWKHJUHHQ\HOORZOHDGWRWKHEUDQFK
FLUFXLWJUHHQOHDGRUEDUHJURXQGOHDG
• Secure all the connections with wire nuts on each
electrical connector.
‡3XVKWKHZLUHVLQWRWKHMXQFWLRQER[DQGUHSODFH
the cover. Be sure the wires are not pinched.
• Secure the MXQFWLRQER[FRYHUZLWKthe 6 RULJLQDO
screws.
-XQFWLRQ
ER[FRYHU
7 INSTALL DUCT COVERS
‡5HPRYHSURWHFWLYHSODVWLF
FRYHULQJ
• Place the decorative duct
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed
IRUUHFLUFXODWLQJSXUSRVHV%HVXUH
the vented end is at the top; the
YHQWKROHVZLOOEHYLVLEOHLQWKLV
installation.
The inside duct piece must slip
into the folded ends on the outer section.
‡([WHQGWKHLQQHUGXFWXSZDUGWRWKHFHLOLQJ
EUDFNHW
• Press up on the front corners of the filter cover panel
WRXQORFN/RZHUWKHSDQHOWRDFFHVVWKHILOWHU
‡/RFDWHWKHVFUHZKROHVRQWKHLQVLGHIURQWHGJH
RIWKHRSHQLQJ,QVWDOOVFUHZVWRVHFXUHWKHGXFW
cover to the hood.
0RXQWLQJ
screws
Vent holes
/RZHUGXFW
cover seat
Duct cover
VXSSRUWEUDFNHW
/RZHU
duct cover
8SSHU
duct cover
Duct attachment
WDEV
Screw holes