GE 24988 GE Infrared Signal Remote Extender - Manual (Page 4)

Before installing the emitter and IR receiver, thoroughly clean the surface.
A. Standard and Preferred installation
1. The preferred method is to attach
the IR emitters directly to the IR
sensor window on electronic device.
2. To locate the IR sensor on your
electronic device, you may have to
use a flashlight to shine into the front of the component through the glass
to find the sensor. The sensor may be a square or round circle
depending on the manufacturer of the electronic device.
(See illustration for an image of a sensor.)
3. Once found, peel the adhesive sticker off the emitter and press firmly onto
the front of the component over the IR sensor. Do not press too hard to break
the front of the component. Please note that the surface must be clean and
dry as well as a flat surface the emitter to adhere properly. The emitter will
not adhere to curved surfaces.
B. Attach emitter on inside shelf
1. Attach emitter on shelf above or below IR
sensor.
2. Press the emitter firmly on the shelf as
close as possible to the IR sensor.
The will flood the area of infrared
signal for the component to receive.