GE 24988 GE Infrared Signal Remote Extender - Manual (Page 5)

C. Cabinet with door installation
1. It may be needed to attach emitter on the
inside of the cabinet door. This method will
flood the area with infrared signal for the
component to receive.
2. Place the emitter directly in front of the
component on the door and press
firmly with the round shape facing the
IR sensor.
D. Installing the IR Receiver
1. Locate a flat surface on the front of your
television or cabinet. Peel the adhesive backing
and press firmly on the desired location.
2. This is the only hardware item visible when the
cabinet doors are closed. Thus, ensure there is a clear line of sight for
the sensor to receive a signal.
E. Testing the device
1. Close the doors to your entertainment center and attempt to change the
channel with your cable box. If the channel changes, congratulations on
the set up of your new IR Repeater!
Troubleshooting
1. Does not have any power
a. Ensure the unit is plugged in properly to the hub as well as into a
110 volt outlet.
2. Blue light indicator on the IR Receiver flashes but unit does not work
a. Occasionally, more reliable activation can occur by moving the IR emitter
further away from the device. This may be due to improper placement of
the emitter, or that the sensor itself is partially obscured.