AC International MTA128ST-USB - Manual (Page 59)

59
Chapter 4 - AT Commands, S-Registers, and Result Codes
S-register: S30
Function:
On-line Inactivity Timer
Unit: 1 minute
Range: n=0 Does not disconnect
n=1–255
Default: 0 (does not disconnect)
Description: Makes the TA disconnect a data connection if no data is transmitted or
received for the specified time. It will NOT cause a POTS call (voice/modem/
fax) to disconnect. The timer restarts any time a data character passes
through the serial port (either sent or received). Disable the inactivity timer
by setting S30=0, which is the factory default setting. S30 currently works for
+ all protocols EXCEPT V.110.
S-register: S31
Function:
Maximum Redial Timeout Value
Unit: 1 minute
Range: n=0 Does not try to redial
n=1–255
Default: 30 (30 minutes)
Description: Sets the maximum redial timeout value for attempts to add a second channel to a
MLPPP data call. Once the maximum timeout is reached, there are no further attempts
to redial. Re-dialing occurs if a call attempt fails due to the host being busy or not
answering. The first redial timeout period is 1 minute. If re-dialing fails after 1 minute,
the next redial timeout is 3 minutes. If re-dialing fails after 3 minutes, the next redial
timeout is 5 minutes. If re-dialing fails after 5 minutes, subsequent redial timeouts occur
every 5 minutes, up to the maximum redial timeout value (S31).
S-Register: S32
Function:
Escape Sequence Timeout
Unit: 100 ms
Range: 0–255
Default: 20
Description: Sets the time allowed in an escape sequence from the receipt of the A in AT to the receipt
of the carriage return. If the S32 time interval expires before you press ENTER, the
escape sequence ends. The default time is 2 seconds.
S-Register: S34
Function:
Maximum Escape Sequence Length
Unit: Decimal ASCII code
Range: 0–10
Default: 2
Description: Sets the maximum character length of the escape sequence, not including +++AT. For
example, a character length of S34=2 allows two characters after +++AT (e.g.,
+++ATH0). Conversely, an invalid escape sequence (too many characters placed in the
command string) passes through as data (e.g., +++atili2). The maximum length of the
escape sequence is 10 characters.