Appendix b: configuration profiles, Quick setup factory profiles, Quick setup example – AC International MTA128ST-USB User Manual
Page 90
90
MultiVOIP 200 User Guide
Appendix B: Configuration Profiles
Quick Setup Factory Profiles
For quick setup, the MTA128ST-USB includes six Quick Setup Factory Profiles, each of which is
configured for a specific type of port operation. You can load a Quick Setup Factory Profile into active
memory by using the command
&Fn, in which n is the number of the profile you wish to load. If you
wish, you can then customize the profile and store it, using the
&W command, so that it loads
automatically when the MTA128ST-USB is turned on or reset. These profiles are stored in permanent
memory and are not user-configurable as such.
&F0
Profile 0—Modem-like operation (default)
&F1
Profile 1—V.110 async operation
&F2
Profile 2—V.120 async operation
&F3
Profile 3—X.75 async operation
&F4
Profile 4—ML-PPP async operation
Note: The &F1 command will return an error when used with build MT128ST-USB-RC.
Quick Setup Example
The following procedure assumes that you want to load, modify, and store Quick Setup Factory Profile
2 as your default configuration.
1.
Select the profile closest to the requirements of your application, in this case— Quick Setup
Factory Profile 2.
2.
In terminal mode, type
AT&F2 and press ENTER. Quick Setup Profile 2 loads into the MTA128ST-
USB’s active memory.
3.
Enter any additional AT commands that you need to customize the selected profile to your
application (see Chapter 4,
AT Commands, S-Registers, and Result Codes).
4.
Type
AT&W0 and press ENTER to save your customized port configuration.
5.
Your customized profile now loads automatically whenever the MTA128ST-USB is turned on or
reset.
Profile 0 (&F0
) — Modem-Like Asynchronous Operation
AT
COMMAND
DESCRIPTION
&C1
DCD functions normally
$D0
Disable persistent DTR dialing
&D1
Hang up when DTR drops
E1
Enable command mode echo
&E4
Enable hardware flow control
&E6
Discard XON/XOFF characters
&E13
Enable pacing
#X0
Disable Sending Multiple Xoff Characters
&J0
Disable Automatic Channel Bundling
%E1
Enable +++ escape method
%E4
No OK response to +++ or <break> escape
&R1
CTS always high