AC International MTA128ST-USB - Manual (Page 92)

92
MultiModemISDN User Guide
S53=2048 Maximum X.75 buffer size is 2048 characters
&S1 DSR follows DCD
V1 Select verbose messages
!Z=6 Enable V.110 data protocol
Profile 2 (&F2 ) — V.120 Asynchronous Operation
AT COMMAND DESCRIPTION
&C1 DCD functions normally
$D0 Disable persistent DTR dialing
&D1 Hang up when DTR drops
E1 Enable command mode echo
&E4 Enable hardware flow control
&E6 Discard XON/XOFF characters
&E13 Enable pacing
#X0 Disable Sending Multiple Xoff Characters
&J0 Disable Automatic Channel Bundling
%E1 Enable +++ escape method
%E4 No OK response to +++ or <break> escape
&R1 CTS always high
S0=1 Answer after 1 ring
S2=43 Set escape character to + (ASCII 43)
S3=13 Set carriage return character to CR (ASCII 13)
S4=10 Set line feed character to LF (ASCII 10)
S5=8 Set backspace character to BS (ASCII 8)
S7=45 Wait 45 seconds for connection before aborting
S10=20 Set DCD drop time to 700 ms
S25=5 Set DTR detect time to 500 ms
S32=20 Set escape sequence guard time to 2 seconds
S34=2 Set maximum escape sequence character length
S50=1 Caller Line ID enabled
S52=1 Auto-Protocol Detection enabled
S53=2048 Maximum X.75 buffer size is 2048 characters
&S1 DSR follows DCD
V1 Select verbose messages
!Z=5 Enable V.120 data protocol
Profile 3 (&F3 ) — X.75 Asynchronous Operation
AT COMMAND DESCRIPTION
&C1 DCD functions normally
$D0 Disable persistent DTR dialing
&D1 Hang up when DTR drops
E1 Enable command mode echo
&E4 Enable hardware flow control
&E6 Discard XON/XOFF characters
&E13 Enable pacing
#X0 Disable Sending Multiple Xoff Characters
&J0 Disable Automatic Channel Bundling
%E1 Enable +++ escape method
%E4 No OK response to +++ or <break> escape