GE 45133 GE Choice Alert Water Leak Sensor - Manual (Page 7)

6 7
Note: If postioning the probe to a metal surface, ensure the
Probe’s contacts do not touch the metal surface.
Next, stretch the cable
vertically and locate a
suitable position to mount
the transmitter. Follow
the same mounting
instructions above for
mounting the transmitter.
Once the Water Leak Sensor
is mounted, you’ll need to
assign it to a Zone on the
Control Center.
Assigning the Sensor to a Zone
Assigning the Sensor into a Zone is an easy four step
process, however there are a few points to remember
- Only one Sensor can be assigned at a time.
- A Sensor cannot be assigned to two different Zones.
- Up to four Sensors can be added per Zone (if a fifth
Sensor is added then the first Sensor will be replaced.)
- Batteries must be active in the Sensor before it can
be assigned to a Zone.
- Sensors can be assigned to a Zone and then
mounted, or can be mounted and then assign to
a Zone.
Follow these steps to assign a Sensor to a Zone.
Step 1 – Press and hold the Learn button on the
Control Center for three seconds. When the
Control Center sounds a long beep, release the
Learn button.