GE 45260 GE Home Monitoring Wireless Color Camera System with Receiver - Manual (Page 6)

6
This system will accommodate up to 2 cameras.
1. Connect one end of the cable (3.5mm male) to the
rear of the receiver, and the other end (white/yellow)
to your television’s A/V inputs. Match the yellow
plug to the yellow VIDEO IN jack and the white plug
to the white AUDIO IN jack.
2. Plug the AC adapter into the power jack (marked
on the back of the receiver, then into an AC outlet.
3. Rotate the antenna to a vertical position. Do not
over-tighten. Place the receiver either on top or
near to your TV.
4. Set your TV to monitor the VIDEO INPUT
designated for the Receiver.
CHANNEL SELECTION
Manual Mode
To select one of the two
channels manually,
press the MANUAL button
on the top panel of the
Receiver. The green LED
will light for the
corresponding channel.
The receiver will switch to a
different channel (1 or 2)
each time the MANUAL button
is pressed. When you have
selected the channel with the
Auto
Manual
Channel
Selection
switch
1
2