Apple Mac G4 (Optical Drive Replacement) User Manual
Optical drive, Replacement instructions, Power mac g4 / macintosh server g4
073-0624 Rev. D
Power Mac G4 / Macintosh Server G4
Optical Drive
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Warning: During this procedure, keep small parts away from children.
Note:
These instructions cover procedures for both QuickSilver models (see page 3) and
the Mirrored Drive Doors/FW 800 models (see page 6).
Tools Required
The only tool required for this procedure is a Phillips screwdriver.
Opening the Computer
Warning: Always shut down your computer before opening it to avoid damaging its
internal components or causing injury. After you shut down the computer, the
internal components can be very hot. Let the computer cool down before
continuing.
1.
Place your computer on a clean, flat surface.
2.
If you think your computer is in sleep, press the power button on the front of the
computer to wake it.
3.
Shut down your computer and wait five minutes before continuing.
4.
If you attached a security cable through the computer’s lockable cover latch, remove
the cable.
5.
Unplug all other cables from the computer except the power cord.
Document Outline
- Optical Drive
- Tools Required
- Opening the Computer
- Removing the Optical Drive in the QuickSilver Models
- Installing the Optical Drive in the QuickSilver Models
- Removing the Optical Drive in the Mirrored Drive Doors/FW 800 Models
- Installing the Optical Drive in the Mirrored Drive Doors/FW 800 Models
- Closing the Computer