Available uses, Settings available when operating on dc, Warning – AirSep 4111-7 User Manual
Page 15
15
When the device is properly connected and receiving power from the DC power source,a green
indicator light on the Power Supply and on the
External Power Indicator, on the control
panel will illuminate.
NOTE: While operating the device from a DC power supply, the Battery may
NOT charge.
NOTE: When operating the Eclipse from a DC power supply, it is recommended
that the Pulse Dose Mode be used.
NOTE: To ensure that the device is utilizing the DC power, check that the
External Power Indicator is illuminated.If the indicator is not illuminated the
battery is powering the device.
SECURE THE ECLIPSE AND DC POWER SUPPLY IN YOUR VEHICLE AND BE SURE THERE IS ADEQUATE
AIR FLOW TO THE ECLIPSE AND THAT THE AIR INLET AND EXHAUST VENTS ARE NOT BLOCKED.
BLOCKING OF THE AIR INLET OR EXHAUST VENT MAY IMPAIR DEVICE PERFORMANCE.
DO NOT LEAVE THE ECLIPSE AND DC POWER SUPPLY PLUGGED INTO THE VEHICLE IF THE IGNITION
IS OFF. DO NOT START THE VEHICLE WHILE THE DC POWER SUPPLY IS CONNECTED TO THE VEHICLE
AND THE ECLIPSE. DOING SO MAY DRAIN THE VEHICLE’S BATTERY.
IF THE VEHICLE’S DC POWER SOURCE DROPS BELOW 11.5 VOLTS, THE ECLIPSE WILL REVERT TO
THE BATTERY OPERATION (IF THE BATTERY IS PRESENT AND CHARGED). (THE EXTERNAL POWER
INDICATOR MAY REMAIN ON.)
AVAILABLE USES
NOTE: When operating with a DC Power Supply, Eclipse settings greater than 2.0 LPM
Continuous Flow, will automatically switch to the 2.0 LPM Continuous Flow setting.
Flow Setting
Continuous
Bolus Size
(mL)
Pulse
0.5
Yes
-
-
1.0
Yes
16
Yes
1.5
Yes
24
Yes
2.0
Yes
32
Yes
2.5
NO
40
Yes
3.0
NO
48
Yes
-
-
56
Yes
-
-
64
Yes
-
-
72
Yes
-
-
80
Yes
-
-
88
Yes
-
-
96
Yes
-
-
128
NO
-
-
160
NO
-
-
192
NO
SETTINGS AVAILABLE WHEN OPERATING ON DC
NOTE: Actual perfor-
mance of the Eclipse
may vary depending
upon usage conditions
of the motor vehicle.
WARNING: