EOTech M914 (AN/PVS-14) Monocular Night Vision Device - Manual (Page 36)

2-16
SECTION II
OPERATING INSTRUCTIONS
2.6 MODES OF OPERATION
The MNVD is powered on by turning the Mode Switch to the
desired position.
CAUTION
Pointing the MNVD at the sun without the lens
cover installed may damage internal imaging
components.
NOTE
The MNVD is equipped with a high light sensor
(see Figure 1-3) that detects ambient light
conditions and automatically shuts down the I
2
tube if conditions are so bright as to risk damaging
internal components. To reset (power on) the
MNVD after a high light shutdown, turn the Mode
Switch to the RESET / OFF position and then back
to the desired setting.