Hootoo HT-WR01 Repeater - Manual (Page 11)

10
Step 7. The Repeater will automatically pre-configure itself with default information
and then reboot. If there are multiple wireless networks or a problem occurs with the
automatic setup, Advanced Configuration may be required. Otherwise the setup is
complete.
Note: Further instruction on Advanced Configuration settings for this device are
available on the following pages, if desired.
8. Once the device is configured, close your browser and connect an RJ45 Ethernet
cable from the Repeater unit to your switch/router (disconnect from the computer if
you used the Wired Setup in Step 2).