Hootoo HT-WR01 Repeater - Manual (Page 5)

4
Installation
Repeater Mode Setup:
Step 1. Connect the Repeater to an available AC electrical outlet.
Step 2. Two Options:
a. Wired Setup: Connect an RJ45 Ethernet cable from the Repeater to your computer.
(Then go to step 3)
b. Wireless Setup: Connect to the wireless network ‘WiFi-Repeater’ (then go to step 4).
Step 3. The default IP address on the Repeater is 192.168.10.1; configure your
computer to a matching network address (192.168.10.x, where ‘x’ is between 2~255)
with subnet set to 255.255.255.0 and gateway to 192.168.10.1. See below:
Step 4. Open a web browser window and enter 192.168.10.1 into the address bar. This
will bring up the login prompt for the Repeater. The default user name and password
Mac
1. Click the Apple menu located at the top left corner of the screen, then select System
Preferences.
2. On the System Preferences window, click the Network icon.
3. On the Network window, select Automatic and Built-in Ethernet on the Location and Show
drop-down fields, respectively.
4. Select Manually on the Configure IPv4 drop-down field. Enter the following:
IP Address: 192.168.10.X (where ‘x’ is between 2~255)
Subnet mask: 255.255.255.0
Router: 192.168.10.1
5. Click Apply Now to save the changes
Windows:
1. Open control panel, open the network section.
2. Or you can right click on the windows bar and select Open network and sharing option
3. Click on Change Adapter Setting
4. Select your Ethernet card and then select properties
5. Under Networking tab find "Internet Protocol Version 4" then select properties
6. Enter the following:
IP Address: 192.168.10.X (where ‘x’ is between 2~255)
Subnet mask: 255.255.255.0
Default gateway: 192.168.10.1
Press APPLY then Ok then REBOOT your computer/laptop for the new settings to take effect.