Jesel INS-09754 Chrysler 340-360 W2 - Manual

Instruction Sheet
Chrysler 340-360 W2
INS-09754
THESE INSTRUCTION SHEETS ARE INTENDED AS REPRESENTATIONS
ONLY. JESEL IS IN NO EVENT LIABLE FOR CONSEQUENTIAL DAMAGE,
INSTALLATION COST OR OTHER COST OF ANY NATURE. NO REPRESEN-
TATIVE IS AUTHORIZED TO ASSUME FOR JESEL ANY OTHER LIABILITY
IN CONNECTION WITH ANY JESEL PRODUCT. NOT RESPONSIBLE FOR
TYPOGRAPHICAL ERRORS.
Machining Instructions:
NOTE: Stand position is determined upon valve length and
rocker pivot length. Please refer to the chart below to determine
the proper machining dimensions.
1) MEASURE VALVE TIP TO SPRING SEAT DIMENSION (DIM
A) AND REFER TO “Z” COORDINATE (DIM B) ON CHART. MILL
OEM ROCKER PEDISTALS DOWN FLUSH WITH THE TOP OF THE
HEAD BOLT BOSS BETWEEN #1 & 3 INTAKE VALVE. THIS IS
YOUR .000” Z HEIGHT. MILL REMAINDER OF ROCKER PEDISTAL
TO COORDINATES LISTED UNDER DIM B.
2) SET THE “X” .000” TO THE CENTERLINE OF #3 & 5 EXHAUST
VALVES. SET THE “Y” .000” TO THE CENTER OF THE FACTORY
3/8 SHAFT MOUNTING BOLTS ALREADY MACHINED IN THE
HEAD.
3) DRILL AND TAP 9/16-12 X .750” DEEP AT “X” AND “Y”
COORDINATES LISTED FOR VALVE LENGTH AND ROCKER BODY
BEING USED. INSTALL SUPPLIED INSERTS INTO HEAD.
4) ATTACH ROCKER STAND USING SUPPLIED BOLTS AND
TORQUE TO 45 FT/LBS.
1.950” -.400” -.085”
2.050” -.300” -.054”
2.150” -.200” -.023”
2.250” -.100” +.008”
DIM B DIM C DIM A
Z COORDINATE VALVE HEIGHT Y COORDINATE
1985 Cedarbridge Ave
Lakewood, NJ 08701
732-901-1800
www.JESEL.com
X+
Y+
Z+
1.515 PIVOT ROCKER -
“A” BODY
1.950” -.425” -.055”
2.050” -.325” -.024”
2.150” -.225” +.007”
2.250” -.125” +.039”
DIM B DIM C DIM A
Z COORDINATE VALVE HEIGHT Y COORDINATE
1.545 PIVOT ROCKER -
“B” BODY