Jesel INS-24001 Chevy BB Individual Bolt Together Stands - Manual

Instruction Sheet
Chevrolet BB
Individual Bolt Together Stands
INS-24001
1985 Cedarbridge Ave
Lakewood, NJ 08701
732-901-1800
THESE INSTRUCTION SHEETS ARE INTENDED AS REPRESENTATIONS ONLY. JESEL IS IN NO EVENT LIABLE FOR CONSEQUENTIAL DAMAGE, INSTALLATION COST
OR OTHER COST OF ANY NATURE. NO REPRESENTATIVE IS AUTHORIZED TO ASSUME FOR JESEL ANY OTHER LIABILITY IN CONNECTION WITH ANY JESEL
PRODUCT. NOT RESPONSIBLE FOR TYPOGRAPHICAL ERRORS.
1985 Cedarbridge Ave ∙ Lakewood, NJ 08701 ∙ Phone: 732-901-1800 ∙ Fax: 732-901-6777
revised 04/08
STEP 1: INSTALL INTAKE AND EXHAUST STANDS
LEAVING 1/4-20 ATTACHING BOLT SNUG BUT LOOSE.
APPLY THREAD SEALANT TO INTAKE BOLT AND OIL TO
EXHAUST BOLT. TORQUE BOLTS TO 60-65 FT/LBS ON
ALUMINUM HEADS AND 65-70 FT/LBS ON CAST IRON
HEADS. USE THE LONGEST BOLT POSSIBLE FOR
MAXIMUM THREAD ENGAGEMENT.
VALVETRAIN INNOVATION
STEP 2: ONCE THE INTAKE AND EXHAUST STANDS
ARE PROPERLY FASTENED, TORQUE THE 1/4-20 x
3/4” JOINING BOLT TO 12 FT/LBS . IF THE STANDS ARE
SHIMMED TO COMPENSATE FOR A LONGER LENGTH
VALVE, THE STANDS MAY NEED TO BE MODIFIED TO
SECURE THEM TOGETHER.
STEP 3: CHECK FOR PUSHROD TO CYLINDER HEAD
INTERFERENCE AND CORRECT IF NEEDED. THE
PUSHROD SHOULD NOT BE ALLOWED TO TOUCH THE
HEAD OR BLOCK THROUGH ANY PORTION OF ITS
TRAVEL. MEASURE FOR PUSHROD LENGTH NEEDED
AND ORDER PUSHRODS. INSTRUCTIONS FOR
MEASURING PUSHROD LENGTH ARE INCLUDED WITH
PUSHROD LENGTH MEASURING TOOL
TOL-29450 .
STEP 4: LUBRICATE THE TIPS OF THE INTAKE AND
EXHAUST PUSHRODS USING THE SUPPLIED HIGH
PRESSURE LUBE. INSTALL EACH ROCKER ARM WHEN
THE CAM LOBE IS ON ITS BASE CIRCLE AND TORQUE
THE 5/16-18 X 1” SHAFT BOLT TO 26-28 FT/LBS . NEVER
TORQUE SHAFT BOLTS WHEN THE ROCKER IS UNDER
ANY SPRING LOAD AS SHAFT DAMAGE MAY OCCUR.