Sper Scientific 840002 Anemometer Hotwire CFM Datalogger - Manual (Page 7)

- 7 -
a. Auto Data Logger (sampling time can be set for 2 seconds to
8 hours, 59 minutes, 59 seconds):
• Press the LOGGER (8) button once, "REC DATA" is displayed and
"Recording. . . ." flashes at each preset interval.
• Press the LOGGER (8) button again to exit. "REC" is still displayed,
but "DATA" is no longer shown.
• To resume data logging, simply press the LOGGER button (8) again.
• To exit the "REC" function, press and hold the REC button (4) for at
least 2 seconds.
b. Manual Data Logger (sampling time MUST be set to "0" zero):
• Press the LOGGER (8) button once to save each data point.
• To exit this function, press and hold the REC button (4) for at
least 2 seconds.
4. ADVANCED AJUSTMENT PROCEDURES
Press the SET button (8) for at least two seconds to enter the advanced
adjustment procedures. Press the ESC (3) button to exit.
4-A. Check Remaining Available of Data Points
Press the SET button (8) at least 2 seconds until the lower display shows:
"XXXXX" is the number of free data points.
4-B. Clear Memory
• Press the SET (8) button as needed to reach the
"clear memory" screen. The number of saved data
points is displayed.
• To delete saved data from memory, press the ENTER (4) button once,
then press ENTER (4) button again to confirm your action. The display
shows: "0 Ok ESC:Quit".
• If you DO NOT want to clear the memory, press the ESC (3) button to exit,
or press the SET (8) button to advance to the next option.
4-C. Date/Time Setting
• Press the SET button (8) as needed to reach
the "date/time set" screen.
• Use the ▲UP (5), ▼ DOWN (6), and ENTER (4) buttons to select the
06:01:03 Date/Time Set
y-m-d ^, v ENTER(→)
XXXXX Memory Space
Before executing the advanced adjustment procedures,
exit the HOLD and RECORD functions.
Clear Memory
Esc:N Enter:Y
107