Sper Scientific 840002 Anemometer Hotwire CFM Datalogger - Manual (Page 8)

- 8 -
year, month, date, hours, minutes and seconds.
• Press the ENTER (4) button to save the settings.
• Press the SET (8) button to advance to the next option, or press the ESC
(3) button to exit.
4-D. Sample Time Setting
• Press the SET (8) button as needed to
reach the "sample time" screen.
• Use the ▲ (5), ▼ (6), and ENTER (4) buttons to select the sample time
(hour-min-sec).
• Press the ENTER (4) button to save the settings.
• Press the SET (8) button to advance to the next option, or press the ESC
(3) button to exit.
4-E. Auto Power Off Default Setting
The meter will automatic shut off after
about 10 minutes without activity.
• Press the SET (8) button as needed to reach the "auto power off" screen.
• Use the ▲ (5) or ▼ (6) buttons to enable / disable this feature.
• Press the ENTER (4) button to save the settings.
• Press the SET (8) button to advance to the next option,
or press the ESC (3) button to exit.
4-F. Temp Unit Default Setting
• Press the SET button (8) as needed to reach the "temp.
unit" screen.
• Use the ▲UP (5) and ▼ DOWN (6) buttons to switch between °F and °C.
• Press the ENTER (4) button to save the settings.
• Press the SET (8) button to advance to the next option, or press the ESC
(3) button to exit.
4-G. Air Velocity Unit Default Setting
• Press the SET (8) button as needed to reach the "default
vel." screen.
• Use the ▲UP (5) and ▼ DOWN (6) buttons to switch be-
tween m/S, Ft/min, Km/h, Knots, Mile/h.
• Press the ENTER (4) button to save the settings.
• Press the SET (8) button to advance to the next option, or press the ESC
(3) button to exit.
1 = Auto Power Off - Enabled
0 = Auto Power Off - Disabled
1 = °F
0 = °C
00:00:02 Sample Time
h-m-s ^, v ENTER(→)
0 = m/S
1 = Km/h
2 = Ft/min
3 = Mile/h
4 = knot