Sper Scientific 840088 pH Kit - Basic - Manual (Page 9)

- 9 -
• Press the ENTER (4) button, then press the ESC (3) button to save the
setting and exit this function.
4-J. Escape from Advanced Adjustments
For the above procedures (B through F), press the ESC (3) button before
pressing the ENTER (4) button to exit advanced adjustments without saving
the changes.
5. UPLOADING DATA FROM THE METER
To upload the data to a computer, connect the RS232 cable and run the soft-
ware (pg 11). You can only send one memory block at a time.
• First, cancel the HOLD and RECORD functions if they are activated.
• Press the SEND (7) button for at least 2 seconds until the bottom right dis-
play shows "Transmit mode."
• Release the button.
• The following screens flash alternately:
• Use the ▲UP (5) and ▼ DOWN (6) buttons to select the desired memory
block number (1 to 250) and push the SEND (7) button once.
• The bottom right of the display shows "Sending Data!".
• When the process has finished, "Transmit mode" is displayed.
• Push the ESC (3) button to exit this function.
Block 1 Block 2 Block 250
………
………
0.3
m/S
xx:xx:xx Transmit Mode 1
m/S
1 Transmit Mode
start time the first data memory block start data address
of each block of each block number of each block (1-250)
The meter can record up to 16,000 data points, stored in a maximum of
250 memory blocks. All data points saved during one data logging ses-
sion are stored in one memory block.
Data 1 Data X+1 Data Z
To Data X To Data Y To Data 16,000