Yetter 1300 Seed Jet II User Manual
Page 6
6
ASSEMBLY INSTRUCTIONS
POWER UNIT SET UP
1. Add oil to blower gear case. DO NOT OVERFILL. 8 oz., 80W-140 gear oil (ISO220, 5EP, GL-5
service grade). Lubricate the bearings using Shell Darina EP NLG grade 2 grease.
2. Fill crankcase of engine with oil. (High quality SAE 30 weight, SE, SF or SG service grade)
3. Fill gasoline tank with clean, fresh lead free gasoline (85 octane).
NOTE: Engine Manufacturer does not recommend the use of gasoline, which
contains alcohol such as gasohol. If gasoline with alcohol is used, it must not
contain more than 10% Ethanol and MUST be removed from the engine during
storage. DO NOT use gasoline-containing methanol.
4. Install and clamp securely a 12-volt battery, Group 58 or 26-70.
5. Check that all electrical connections are tight.
6. Check tension of drive belt.
7. Ensure that all safety shields are in place.
NOTE: For questions concerning warranty on the engine or blower contact the
corresponding manufacturer or the local service/retail outlet.