Yetter 1300 Seed Jet II - Manual (Page 9)

9
ASSEMBLY INSTRUCTIONS
STEP 3. Attach the 1300-163 cable assembly to the 1300-124 seed hose assembly. Connect the 1300-
163 cable to the power unit’s module at the plug connector labeled “switch input”. Inspect the plug
connector for dirt, debris or bent pins; clean and repair the connectors if necessary.
STEP 3. CONTINUED….Coil the cable assembly around the seed hose. Install the toggle switch to the
cyclone handle and secure with the jam nut.
STEP 4. Tape the seed hose assembly and the cable assembly together at regular intervals to prevent
snagging and damaging of the cable assembly.