Yetter 1310-010 Maximizer - Manual (Page 4)

4
CAUTION
1. Read and understand instruction manual before operating.
2. Keep all safety shields and devices in place.
3. Make certain everyone is clear before operating machine.
4. Keep hands, feet, and clothing away from moving parts.
5. Shut off power to adjust, service, or clean.
6. Make sure machine is secured before operating.
7. When transporting, shut fuel lever off.
8. DO NOT operate machine when guards are removed.
Pre-Operating Check List:
1. Service the gas engine and gear reduction box.
2. Connect the wire harness.
3. Check all bearings for proper lubrication.
4. Check the tube for foreign material.
5. Check all belts for proper tension.
6. Tighten all setscrews.
7. Start unit and check tender belt alignment while unit is empty.
BELT CARE……..
It is suggested that the unit be run every two to three days or more often if possible. This tends to keep the
tender belt alive and stops any forming of the belt to the curvature of the tube while the unit is not in use.
NOTE: Belt may deteriorate if not in use and exposed to weather conditions for any prolonged period of
time.
Operation Sequence
1. Check drive belt for proper tension.
2. Make sure tender belt is properly tensioned.
3. Allow unit to run empty for a few minutes to flex tender belt.
4. Check tender belt for proper alignment.
5. Before shutting power off, be certain drive belt and tender belt are empty of seed.
STORAGE…………
Temporary Storage
1. Relieve tension from all belts; both v-belt and tender belt.
2. Store all belt equipment in a dry place. If equipment cannot be stored out of the weather, cover
engine and mechanical parts with waterproof material.
IMPORTANT
Prolonged Storage
1. Remove all belts and store in a cool, dark, dry place.
2. Wash tender belt thoroughly.
3. Wash tender tube both inside and out.
4. Lubricate all bearings.
5. Store in a dry shelter.