Yetter 1310-010 Maximizer - Manual (Page 9)

9
SERVICE…
1. Check engine oil level daily.
2. Change engine oil every 25 hours.
3. Check for oil leaks daily.
4. Grease bearings every 50 hours.
5. Check bearings annually.
6. Check belt tension and adjust as required. Belt tension should be just enough to drive the belt. Belt will
require 10 hours of operation to break in. Some adjustment may be required at this time.
7. Belt and splice should be in good condition, check daily.
BELT REPLACEMENT INSTRUCTIONS
Route both ends around head and tail roller, slide belt forward and back through tube so ends
of the belt meet at a convenient location.
Align and interlace belt and clipper lacings. Slip splice pin through clipper lacings to secure.
NOTE: The clipper lacings are connected on a metal strip that needs to be broken to allow
the belt to flex.
Tighten belt by turning adjustment nuts on head roller assembly in. Tighten evenly on each
side until belt is tight.
To train belt, see belt training instructions in this manual.