Yetter 2967-180 Residue Manager for 2959 Offset Injection Coulter - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
GENERAL INFORMATION
Examine all equipment carefully for damage or shortages.
Lubricate all bearings and moving parts as assembled.
Reference to front, rear, left and right in this installation instruction are made when sitting in the operator’s
seat facing direction of forward travel.
BOLT TORQUE
READ THESE INSTRUCTIONS FIRST:
1. Improperly tightened bolts will result in damage, breakage, expense, and down time.
2. Always replace bolts with the specified grade and type.
3. Torque properly before first use of the machine and every 2-4 hours of use until you are sure bolts are
staying tight.
4. The chart below is a guide for proper torque. Use it unless a specified torque is called out elsewhere in
the manual.
5. Torque is the force you apply to the wrench handle or the cheater bar, times the length of the handle or
bar.
6. Use a torque wrench whenever possible.
The following table shows torque in ft. lbs.