GReddy FATT Full Auto Turbo Timer - Manual (Page 13)

Countdown Mode
Auto Countdown Mode
12
Auto Timer Mode automatically calculates a suggested count down time
for your vehicle, according to your car’s RPM. You may also choose
2 count down time offset ratios "Hi" or "Lo". This will add a preset time to
your calculated count down time.
On some vehicles, there is a possibility that the Auto Mode will not
function properly due to difference in usable rpm range.
The Turbo Timer begins calculating, when your RPM reaches
approximately 3000 RPM for "LO" mode and 2000 RPM for
"HI" mode.
A minimum value can be set from 0 sec. to 1 min 30 sec. by increments
of 10 sec. The factory setting is 0 sec.
(1) Press the P+S switch to
display -L- or -H-. Two sec.
later, the current minimum
offset value will be displayed.
(2) By pressing the T switch (once),
you can increase the minimum
value by 10 sec. increments
(3) By holding down the T switch,
you can increase the minimum
value by 30 sec. increments
(4) 3 sec. after releasing the T
switch, the unit will alert a
confirmation beep. Then the
unit will switch back to -L- or
-H- mode. (2 sec. later the current
minimum value will be displayed.)
2 sec. later
2 sec. later
Press T 3 times to
set to 30 sec.
This show -L- being
selected.
After the setting is
confirmed the minimum
setting is displayed
When the vehicle starts
to move, it will start
to add time to the
minimum set time.
Auto Timer Minimum Setting