GReddy INTERCOOLERS: Mitsubishi Evolution 2001-07 / Type32R - Manual (Page 5)

5
２ ２ ２ ２． ． ． ．
Removing Factory Parts
２－１
Please remove the negative (-) terminal from the battery.
２－２
Remove the engine undercover panels.
２－３
Remove the front bumper cover.
２－４
If you have the GReddy turbo kit, please remove compression pipe C-2.
２－５
Remove air hoses B/C/D/E and air pipes B/C.
２－６
Remove the factory intercooler.
２－７
Drain the P/S fluid and remove the P/S cooler. Disconnect the factory P/S hose as designated by
the arrow.
３ ３ ３ ３． ． ． ．
Relocation Kit
３ ３ ３ ３－ － － －１ １ １ １ Ｐ Ｐ Ｐ Ｐ
/
Ｓ Ｓ Ｓ Ｓ
Cooler Installation
（１）
Mount the P/S cooler according to the image
using the P/S cooler clamps and 6mmx15mm
nuts and bolts.
(Parts used:
１３
,
４
,
１５
,
２０
)
（２）
Use the provided 9mm hoses (960mm and
1070mm) please cut them to fit. The 1070mm
hose is installed on the upper portion of the
P/S cooler and the 960mm hose should be
installed on the lower portion. Use the
provided hose bands to secure the hose ends.
(Parts used:
９
,
１８
)
Please follow the factory repair manual procedures when
removing the parts.
１０７０㎜
９６０㎜