Monoprice 9207 IP Camera Converter - Manual (Page 8)

MPEG-4 Video Server
4. RS485 – for pan/tilt control, Pelco-P and Pelco-D protocols supported.
5. The pin sequences are DI(+),DI(-),DO(+),DO(-),RS485(+),RS485(-).
6. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the
Ethernet link is ok, the Ethernet indication LED on the front side will be blue light.
7. Status indication LED (red) – this LED is to indicate the Internet connection status.
When the Internet connection is connected, the LED will be constant red light. If
there is any Internet connection problem, the LED will be blinking red light.
8. Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok
and packet traffic is sending/receiving. When the Ethernet cable is connected, the
LED is constant blue light. When there is packet sending/receiving, the LED is
blinking blue light.
9. Micro-SD card slot – for inserting the micro SD-Card. .
Figure 2-2: Major components in the back panel
2.2. Quick installation and usage
There are only four steps that you need to do to see the video from the video server
product.
1. Connect a CCTV camera to the video server product.
2. Connect the video server product to the home/office network.
3. Install the CamView software on the notebook/PC.
4. Key in the ID/password of the video server product (from the ID/Password card)
on the CamView, and then you can see the video.
First, Connect a CCTV camera to the video server product
Please connect a CCTV camera to the “video in” connector in the video server
product as shown in Fig.2-2.
8