Night Owl PE-DVR16-1TB user manual - Manual (Page 50)

50
Chapter 15: Advanced Menu
15.1.1.3 Trigger Screen
The Trigger Screen allows you see what has triggered an alarm.
To access the Trigger Screen, select the Advanced button, select
Alarm
from the list on the left side of the screen, and then select Motion. Select
Settings in the Trigger column for the channel you are configuring.
•
Record: Instructs the DVR to start recording when motion.
•
Snapshot: Saves a picture of what has triggered the alarm.
•
Send Email: Sends a snapshot to an email address that has been
configured.
•
Alarm output: This has no function.
•
Alarm output duration: This has no function.
•
Buzzer: Causes the DVR to beep if alarms have been detected.
•
Pop-up Screen: Enlarges the channel to the full screen of the
channel that has detected the alarm.
•
Pre-Record: Select the duration that the DVR will record before an
alarm is triggered.
•
Post-Record: Select the duration that the DVR will record.
•
PTZ: If you have a PTZ (Pan-Tilt-Zoom) camera connected, select
whether you would like the camera to move to a preset point.