Night Owl PE-DVR16-1TB user manual User Manual
Page 86
86
Chapter 22: Port Forwarding
Chapter 21: Remote Access
5. You will need to enter a new port forwarding entry for each port that
your DVR uses:
Media Port (
9000
),
Web Port (
2051
). Repeat the
steps below for each entry.
6. When entering the port numbers and IP address into your router’s
port forwarding section, you will need to do away with the leading
zeros (e.g., 09000 becomes 9000, 192.168.000.150 becomes
192.168.0.150, and so on).
7. In the port forwarding section of your router, you will typically be
asked to enter the following information in order to forward a port
(keep in mind that the wording may be different, depending on the
model of your router):
a.
Application Name: This can be anything you choose.
b.
Public Port: This should be set to one of the three ports
you need to forward: Media Port (9000), Web Port (2051).
c.
Private Port: This should be set to the same number you
entered for the Public Port.
d.
Port Type/Protocol: If your router has an option for both,
use TCP and UDP. If your router allows either TCP or UDP
port types, use TCP.
e.
Host IP Address: This should be set to the IP address you
configured for your DVR earlier.