Outback Power Systems VFX Series International Programming Manual - Manual (Page 35)

34
BYPASS OUTPUT INPUT
With the programming completed,
turn the AC output breakers ON
with the AC BYPASS on the AC
breaker panel switched to NORMAL.
Verify the AC voltage output through the MATE following path:
PATH
MAIN--------------------- SETUP------------ STATUS/FX/PAGE1---------- Float P00 STATUS/FX/METER—P00
12.15:30p choose device: choose category: inv 0.0Kw zer 0.0kw output 230 vac
chg 0.0kw buy 0.0kw voltage
SUM STATUS SETUP ADV FX CC DC MAIN MODES METER BATT PG2 DOWN STATUS PORT DOWN UP TOP PORT
POWERING UP