Outback Power Systems FLEXmax Extreme Owners Manual - Manual (Page 33)

Operation
900-0150-01-00 Rev A 31
Stats Screen
From the Charge Controller screen, the <Next> soft key proceeds to the Charge Controller Stats screen. This
screen shows data which has been accumulated since the system went online, or since the last reset.
Figure 28 Stats Screen
Figure 29 Stats Reset Screens
Soft Keys:
<Maximums> proceeds to the Reset screen for the Maximum
statistics (see Figure 28).
<Totals> proceeds to the Reset screen for the Total.statistics (see
Figure 28.)
<Back> returns to the previous screen.
<Port> cycles through each device connected to the network.
<No> returns to the previous screen without resetting.
<Yes> proceeds to a
confirmation screen after
resetting the item (see
example to the right).
<Continue> returns
to the Charge Controller
Stats screen.
Screen Items:
The Reset screens allow the items in the Stats screen to be reset to
zero. The Yes soft key is used for resetting. The items under
Maximum and Total can be reset independently. Until then, they
will continue to register higher numbers or greater accumulations.
Soft Keys:
<Next> proceeds to the Error, Datalog, and Temps screens
(see pages 32 and 33).
<Reset> proceeds to the Reset screens for the items under
Maximum and Total. (See Figure 29.)
<Back> returns to the previous screen.
<Port> cycles through each device connected to the network.
Screen Items:
The items under Maximum are not incremental.
They are updated only if a higher value is measured.
VOC displays the highest measured V
oc
value. (See
the VOC reading on page 30 for the current V
oc
.)
Battery displays the highest measured battery
voltage. (See the
Out reading on page 30 for the
current battery voltage.)
Wattage displays the highest measured wattage
harvested from the PV. (See the
Out reading on
page 30 for the current wattage. See the Maximum
reading for the highest wattage that day.)
The items under Total are incremental. These items
are updated daily with higher totals.
kWh displays a historical accumulation of the
kilowatt-hours harvested by the controller. (See the
Out reading on page 30 for the daily accumulation.)
kAh displays a historical accumulation of the
kiloamp-hours used to charge the batteries. (See the
Out reading on page 30 for the daily accumulation.)