State SBL95 250NE A - Manual (Page 21)

21
installation diagrams - top inlet/outlet usage
Use of the top inlet water connection requires an inlet dip tube
(refer to figure 19). The tube is supplied in the heater. Follow
caution labels if applying heat to this fitting. Do not allow pipe
dope to contact the plastic tube during installation.
tuBe inlet installation
figure 19.
temperature setting should not exCeed
safe use temperature at fixtures. see water
temperature Control and mixing ValVes on
page 12. if higher preheat temperatures are
neCessary to oBtain adeQuate Booster output,
add an anti-sCald ValVe for hot water supplied
to fixtures.