Posey Bed 8070 - Manual (Page 12)


12 Posey Bed - 8070
Long Rail Assembly
Materials:
• Hardware Packet A
• Part G (2)
• 9/16” wrench
This section requires two people.
1. Hold and align one of the long rails (Part G)
between the left head and left foot posts
(Parts H & M) (Fig. 5-C).
2. Place a locking washer on four (4) 1” bolts
(Hardware Packet A) and insert one into each
hole of the corner connection. (Fig. 5-D).
3. Hand tighten the bolts loosely until all rails are
installed (Fig. 5-E).
Fig. 5-B
Locking
Washer
Bolt
L
Fig. 5-C
L
G
H
Fig. 5-D
L G
H
Fig. 5-E
L
G
H
Short Rail Assembly
Materials:
• Hardware Packet A
• Part L (2)
• 9/16” wrench
This section requires two people.
1. Hold and align one of the short rails (Part L)
between the left and right head posts (Parts H & I).
NOTE: Make sure the holes on the posts face
inward on both sides of the frame (Fig. 5-A).
2. Place a locking washer on two (2) 1” bolts
(Hardware Packet A) and insert one into the
hole facing the inside of the post. (Fig. 5-B).
3. Hand tighten the bolts loosely until all rails are
installed.
4. Repeat on the other side of the rail. Repeat
with the second short rail between the left and
right foot posts (Parts M & N).
Bed Assembly
Fig. 5-A
Hole Direction
Inward
L
H