Posey Bed 8070 - Manual (Page 9)

Posey Bed - 8070 9

Transfer Brake Assembly
Materials:
• Hardware Packet D
• Part O (4)
• 7/16” wrench (2)
1. Align the top and bottom holes on the Transfer
Brake (Part O) with the two holes on the bed
frame.
NOTE: Make sure the holes in the brake are facing
the holes in the bed frame (Fig. 3-A).
2. Insert two bolts (Hardware Packet D); one into
the top hole, and one into the bottom hole of
the transfer brake (Fig. 3-B).
3. Place a nut on each bolt (Fig. 3-C).
Fig. 3-A
Top
Hole
Bottom
Hole
O
4. Use a 7/16” wrench to tighten both bolts (Fig. 3-D).
NOTE: Two 7/16” wrenches are needed: One to
hold the bolt, and the other to hold the nut.
DO NOT over tighten.
5. Repeat steps 1-4 until all four transfer brakes are
properly installed.
6. Turn the bed assembly upright and lock all four
casters by pressing down on the lock on each
caster (Fig. 3-E).
Turning the bed upright
requires two people.
NOTE: The bed platform cannot be raised,
lowered or articulated unless the power cord
is plugged into an appropriate grounded AC
electrical outlet. Locate the control pad in the
packaging under the bed frame to raise and
articulate the frame.
Fig. 3-C
Fig. 3-D
Fig. 3-E
Foot
Side
Head
Side
Fig. 3-B
O
Top Hole
Bottom Hole
D
Bed Assembly