Vaisala RDP100 - Manual (Page 7)

4. Remove the stainless steel
front cover by pulling the bottom
part of the cover away from the
housing. You can also insert a
slotted screwdriver in the slot on
the bottom of the housing, and
lift to remove the cover.
5. Connect wiring to the
detachable screw terminal.
Refer to the terminal label on the
back of the housing, and to the
wiring instructions in this guide:
HMDW110 series: Wiring
HMDW110 with RDP100 on
page 9.
Other supported instruments:
Wiring on page 8.
6. Depending on the instrument
you are connecting, you may
have to insert the jumper to
numbered pins that are located
to the right of the DIP switches.
Follow the wiring instructions.
7. When you are finished with the
wiring, plug in the screw
terminal. If supply voltage is
connected, the RDP100 will
start up at this point.
5