Vaisala DPT146 - Manual (Page 38)

User's Guide _______________________________________________________________________
36 ___________________________________________________________________ M211372EN-D
List of Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
Table 6 List of Serial Commands
Command Description
? Show device information
?? Show device information (overrides poll mode)
ADDR [0 … 255] Show or set transmitter address
AERR Set analog output error level
AMODE Set analog output mode
AOVER [ON/OFF] Allow analog outputs to exceed their range 10%
ASEL Set analog output parameters and scaling
ATEST Test analog outputs
CLOSE Close the temporary connection and return the
device to POLL mode
ERRS Display the currently active errors
FORM [modifier string] Set output format
FRESTORE Restore factory settings
HELP Show list of currently available serial commands
INTV [0 ... 255 S/MIN/H] Set the continuous output interval (for RUN mode
and R command)
OPEN [0 … 255] Open a line to transmitter at defined address
R Start the continuous outputting
RESET Reset the transmitter
S Stop the continuous outputting
SDELAY [0 … 255] Set response sending delay
SEND [0 … 255] Output readings once (specify address for
transmitters in POLL mode)
SERI [baud p d s] Show or set the serial interface settings
SMODE [mode] Show or set startup serial mode:
RUN, STOP, POLL, or MODBUS
SNUM Display transmitter serial number
TIME Show transmitter uptime
UNIT [m/n] Select metric or non-metric units
VERS Show transmitter firmware version