Figure 14, Caution – Vaisala RS92-SGP User Manual
Page 28
User's Guide ______________________________________________________________________
26 __________________________________________________________________ M210295EN-H
2.
Connect the communication cable to the Ground Check Set
interface in the radiosonde. Text "UP" on the connector faces
upwards.
0705-026
Figure 14
Radiosonde in the GC25 with the
Communication Cable Connected
3.
Switch on the PC and start a new sounding with the sounding
system software. For detailed instructions, see the sounding system
documentation.
4.
Switch on the Ground Check Set by pressing the power switch. The
green LED in the power switch is lit.
The sounding software goes through reconditioning, frequency
tuning, timer setting, and ground checking.
5.
When the sounding software is finished, it indicates that it is ready
for radiosonde release dy displaying a message. Remove the
radiosonde from the Ground Check Set and disconnect the
communication cable.
CAUTION
Do not press any buttons in the Ground Check Set while the sounding
software is performing.